Baby Bullet + Orbiter 1.5 + E3D V6 (Threaded Heatsink).Baby Bullet + Orbiter 2.0 + E3D Revo6 (Threaded Heatsink).Baby Bullet + Orbiter 1.5 + Phaetus Dragonfly.Baby Bullet + Orbiter 2.0 + Phaetus Dragonfly.(Coming Soon!) Baby Bullet + Orbiter 1.5 + Phaetus Rapido.(Coming Soon!) Baby Bullet + Orbiter 2.0 + Phaetus Rapido.Note that the quantity is for two extruders.Īlso note that there are two heatsink types supported, but they have slightly different hardware: Other versions of this tool exist in the wild too.Īll parts to buy for a groovemount-style hotend are called out in this spreadsheet tab. The spreadsheet above is for a groovemount style threaded heatsink. replace the 4x M3, 20mm screws with 4x M3, 25mm screws.1x E3D Nozzle Spanner Wrench for hot-tightening the nozzle. 1x Small Crescent Wrench or E3D Gripper Wrench for hot-tightening the nozzle.1x 3D-Printable M12 Threaded Heatsink Wrench (only if you are building a threaded heatsink style tool).Recommended: Heat-Set Insert Installation Tip.Budget Soldering Iron for installing heat-set inserts. uncheck "Detect Thin Walls" if your Slicer has this settings or small gaps will not be filled.6 perimeter layers ← this is esp important for parts with heat-set inserts.Print parts specific to your setup with the following print settings: This one will work for M3 and M4 inserts. Please check the table below for print setting exceptions. Note that parts that peel off the bed with a small curl cannot be used. Orbiter 1.5 + Groovemount Heatsink (V6 / Dragonfly) They must stick to the bed such that they remain flat. You will need to attach a 37104-A165-00E MB connector ( Farnell) to the motor wires on the orbiter motor.Threaded-Heatsink Style Tool Assembly Instructions.Groovemount Style Tool Assembly Instructions.Print with support material from the build plate only.įor properly aligning parking post pins during assembly Orbiter 2.0 + Groovemount Heatsink (V6 / Dragonfly)Īll parts below are common to all tool variations:įor V6 Hotend Heights. Here are the general operating conditions adapted from the Orbiter Thingiverse page: No wire stripping required! Just insert the wires and compress the housing with a wrench.
0 Comments
Leave a Reply. |