![]() Unfortunately, if your transmission is failing, there's nothing you can do yourself but have it serviced/replaced. DO NOT OVERFILL! If your problems persist, then the trans is going bad. Then check the fluid level) If it's low, add fluid to bring it to the proper level. ![]() With your foot on the brakes, cycle the transmission through P.R.N.D.1.2. However, there are other possible conditions you should consider. This part is needed to control engine temperature. (Make sure the engine is at full operating temperature. The most common cause of the P0128 trouble code is a stuck open thermostat. The coolant and oil level sensors would have absolutely nothing to do with that.įirst check the fluid to see if it's at the proper level. (Make sure the engine is at full operating temperature. (Less likely than the coolant sensor)Īs far as you car jerking and pulling slow when you accelerate, that would be a transmission issue. First check the fluid to see if it's at the proper level. Rep: 680.5k MacHale Enterprises 3.1k 1k 2.6k Posted: Options The causes of white exhaust smoke can vary however, it is common to see white exhaust smoke when first starting a car, especially on cooler days. But it is possible that the sensor has failed also. The low signal that the PCM detects from the ECT sensor can mean that the engine coolant is excessively hot. ![]() You'll have to consult your owners manual for that. If you were low on oil, but then filled it to proper capacity, then the oil level sensor may have to be reset. (These sensors often fail on high mileage vehicles) According to the National Bureau of Statistics (NBS), Nigeria recorded a slight GDP growth of 0. It sounds as if you have several, unrelated problems.įirst, if your coolant sensor says you're low on coolant but you're not, then the sensor is bad or clogged up with debris. The rural inflation rose to 12.28 in July 2020, up from 11.99 in June 2020. ![]()
0 Comments
Leave a Reply. |